Low Cost wooden powder briquetting machine in Indonesia

Low Cost wooden powder briquetting machine are used to convert powdery material into rod-shaped products under high pressure and temperature. This equipment has some requirements for the raw material. Firstly, the diameter of the raw material should be shorter than 10mm. Secondly, the moisture content of the raw material should lower than 12%. After the forming process in the biomass briquetting machine, the formed hollow rods will be put into a carbonation furnace.

EP biomass briquetting machines can take many biomass wastes as material. Some of them need to be crushed into small particles before the briquetteing process. The most common materials are saw dust and rice husk. These two kinds of materials are small enough, so it is not necessary to crush them before putting them into the Low Costwooden powder briquetting machine.

The working principle of Low Cost wooden powder briquetting machine in Indonesia is quite simple. The crushed materials(twigs, stalks, straws, cotton stalks...) will be added into the feeding port. There is no need to add any adhesive in the powdery materials. Under high temperature and pressure, the materials will be pressed into high-density briquettes.

Each Low Costwooden powder briquetting machinein Indonesia is equipped with an automatic electric heating appliance. To some extent, this heating appliance can adjust moisture content of the material. As a result, the forming effect of the machine is guaranteed and working efficiency of the machine has been improved.

The scientific structure of the Low Cost wooden powder briquetting machine in Indonesia makes it possible to operate the machine easily. And you can use the machine to make high-density briquettes. For your reference, the ratio of briquetting of the forming machine is above 96%.

Biomass raw material such as wood branches, bamboo dust and crop stalks need to go through four steps to be finished charcoal products. The four processing steps are crushing process, drying process, briquetting process(Low Costwooden powder briquetting machine and carbonizing process.

Charcoal rods which are produced by Low Costwooden powder briquetting machinein Indonesia can be used in steel mills in order to make high-quality steel. In a word, charcoal briquettes are widely used in different industries, and the market demand of it also becomes large. As a result, biomass briquette machines are widely praised.in the international market. The usage of biomass briquette machines has greatly reduced the cost of making people's charcoal sticks, while profit multiples at the same time.

Researching and developing biomass energy has become a hot topic in the world. The biomass charcoal briquette is one of the research achievements. Make use of biomass briquettes as fuel is cleaner than to use fossil fuels such as oil and coal. Low Costwooden powder briquetting machinein Indonesia is an important equipment in this industry

The main business item of our company is to produce Low Cost wooden powder briquetting machine in Indonesia and charcoal briquette production lines. Our briquette machines are eco-friendly equipment and this kind of briquetting machine is one of the best-selling machines on the international market.

It is common that pilot run should be done before the wooden powder briquetting machine is put into use. Biomass briquette equipment is no exception. It should idle without any load for about 3 minutes at the beginning. If everything goes smoothly, you can add some material into the feeding port.