High Output wood biomass briquette machine in Nigeria

The High Output wood biomass briquette machine can turn forest wastes and crop wastes which contain wood fiber into flammable briquettes through the technique of hot compression molding. Compared with the similar machines of other manufacturers, the biomass briquette machines of our factory are more advanced.

Our biomass briquetting equipment employs corn stalks, corncob, twigs, leaves and saw dust as raw materials. Firstly, you need to use an EP crusher machine to make those materials into small particles or powder. Then the crushed material will be compressed in the High Output wood biomass briquette machine in Nigeria.

High Outputwood biomass briquette machinein Nigeria employ the working principle of extruding materials under high pressure and high temperature. The components of EP biomass briquetting equipment are made of high-quality material.

Each High Outputwood biomass briquette machinein Nigeria is equipped with an automatic electric heating appliance. To some extent, this heating appliance can adjust moisture content of the material. As a result, the forming effect of the machine is guaranteed and working efficiency of the machine has been improved.

High Outputwood biomass briquette machinein Nigeria adopt v-belt drive which can make the machine work smoothly. In addition, v-belt drive can also act as overload protection device. Moreover, there are two connection modes of the machine head and the cylinder body: insert connection and bolted connection. And you can choose the best connection mode according actual situation.

At the beginning, the raw materials will be crushed into small pieces. If the moisture content of the raw materials is high, then they need to be dried. After the drying process, it comes to the core procedure of the production line: briquetting. After the raw materials are made into briquettes by High Output wood biomass briquette machine in Nigeria, you can choose to put them into a carbonation furnace to make charcoal briquettes or pack them directly. In general, many people choose to conduct the carbonizing process because charcoal briquettes value more than “raw briquettes” that don’t go through the carbonizing process.

In industrial engineering, charcoal briquettes that are made by High Output wood biomass briquette machine in Nigeria can take place of coal and heavy oil to be fuel for heating steam boilers. In addition, the charcoal briquette can also be used as material to make activated carbon, silicon carbide and so on. Therefore, charcoal briquettes are necessary material in mosquito-repellent incense plants, explosive factories and casting factories.

Biomass fuel is an important renewable energy resource. Nowadays, under the situation that fossil fuel becomes less and less, biomass energy aroused people’s wide concern. Charcoal briquettes made by High Output wood biomass briquette machine are the most common biomass fuel whose ash content and sulphur content is relatively low. That means it will not cause many pollutants to use charcoal as fuel.

Every time you turn on the switch of a wood biomass briquette machine in Nigeria, you should check the flexibility of machines’ rotating parts and make sure there is no abnormal noise. What’s more, before add material into the feeding port, the machine should idle for 2-3 minutes.

It is common that pilot run should be done before the wood biomass briquette machine is put into use. Biomass briquette equipment is no exception. It should idle without any load for about 3 minutes at the beginning. If everything goes smoothly, you can add some material into the feeding port.