Correction method for the negative phenomenon of pellet machines - Service - Zhengzhou E.P Machinery Co., Ltd. - Biomass Briquette Machine,Wood Pellet Machine

Summary ：Any equipment that operates with bad quality, improper installation, wrong operation, and poor maintenance may have much undesirable performance. So, what should we do if there is a bad phenomenon in the pellet machine? What are the corrective methods?

Any equipment that operates with bad quality, improper installation, wrong operation, and poor maintenance may have much undesirable performance. So, what should we do if there is a bad phenomenon in the pellet machine? What are the corrective methods? The following content will give you a detailed explanation:

1. The length of the pellets varies too much. The cutter distance of the pellet machine should be adjusted or the deflection and scraping position of the splitting material should be adjusted.
2. The surface of the pellet is smooth, but the hardness is too high. It may be because the compression rate of the ring die pellet machine is too big. So we need to reduce the ring die compression rate.
3. The surface of the pellet is not good, and there is a lot of dust. It may be that the compression ratio of the ring die is too small, therefore the compression ratio should be enlarged.
4. When the moisture is high, the machine may be jammed, in which way the tempering temperature of the wood pellet machine can be increased accordingly, and that will be benefit for the material maturity temperature increase.
The above cases are the corrective method for problems that occurred on pellet machines. Hoping these methods can help you. These problems can actually be prevented before the machine is operated, but it is necessary to prevent them according to the corresponding reasons, so the above content better be well known.