search

Solutions to problems on using feed pellet machine

2019-12-27 13:59:00
E.P
Original
656
Summary :E.P will list some problem you may encounter when using a feed pellet machine, and will tell you the corresponding solutions to the problems.

In general, after putting the feed pellet making machine into use for a while, you mayencountersome little problems which are likely caused by careless operation during the production of feed pellets. Some people might don’t know how to solve the problems when the problems occur. In this article, E.P will list some problem you may encounter when using the machine, and will also list the corresponding solutions to the problems.

feed pellets

Firstly, the surface of the finished feed pellets is rough, or there are some cracks on the surface of the feed pellets. If this phenomenon occurs, that indicates there is something wrong with the cutter of the feed pellet machine. If thecutter is intact, thesurface of the finished feed pellets will smooth, andthe feed pellets will be uniform in size.

animal feed pellet extruder

Secondly, the surface of the feed pellets is too smooth, and the density of the pellet is too high. Some people might think it is a good sign, but actually, it is not. This problem means the compression ratio of the feed pellet machine is too high. Thus, what you should do is to loosen the mold to some degree. For your reference, theproblem rarelyhappens, so you don’t need to pay much attention on this. What’s more, you should make sure there is no hard impurities in the material.

feed pellet making machine

Thirdly, the feed pellet machine is clogged by the raw material. This is mainly because that the material you use is of high moisture content. If you encounter this kind of problem, you should stop the machine and clean the machine immediately. In order to avoid the situation: material clogged in the pellet machine, you should use some dry material to make feed pellets. If the material you have is too wet, then E.P suggests you use a drying machine to reduce the water content of the material.

Write a Comment
Comment will be posted once reviewed.